Expo 2020 - Dubai, UAE
scroll to down
guarantee image

OpenVox D110P is the worldwide affordable single port T1/E1/J1 card and delivers the great voice quality over telephony systems. It supports up to 30 voice calls or 2.048 Mbps of full–duplex data throughput over one T1, E1, or J1 lines

Single T1/E1/J1 port with PCI/PCI Express interface for high performance voice and data applications

Up to 30 Simultaneous voice calls

OpenVox D110 supports E1, T1 and J1 environments. It is selectable on a per-card or per-port basis. This feature enables signaling translation between E1 and T1 equipments and allows inexpensive T1 channel banks to connect with E1 circuits.
D110 supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported.
D110 works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications.

OpenVox Elastix&trixbox certified
Target Applications

  • Voice-over Internet Protocol (VoIP) Services
  • Complex IVR Trees
  • "Meet-Me" Bridge Conferencing
  • Calling Card Platforms
  • VoIP Gateways (support SIP, H.323, and IAX)
  • Legacy PBX/IVR Services
  • Voice/Data Router (replasce expensive routers)

Specifications

  • SingleT1/E1/J1 port with PCI/PCI Epress interface for high performance voice and data applications
  • Half-length PRI card
  • RJ48 connector
  • 32 bit 33MHz PCI and fully PCI 2.3 compliant
  • 32 bit bus master DMA data exchanges across PCI interface at 132 Mbytes/sec
  • Autosense compatibility with 5 V and 3.3 V PCI busses
  • Power: 1.2W Maximum at 3.3 V or 5 V.
  • Operation temperature: 0°C to 50°C
  • Storage temperature: -65°C to 125°C
  • Dimension: 12.3cm*6.5cm*1.8cm
  • Weight: 54g

PRI Switch Compatibility:

  •     EuroISDN (PRI or PRA) - Q.931/Q.921
  •     Network or CPE
  •     AT&T 4ESS
  •     National ISDN 2
  •     CAS Voice Modes
  •     DMS 100
  •     Lucent 5E
  • Operating Systems: Linux (all versions, releases and distributions from 1.0 up)

Minimum Hardware Requirement:

  •     800-Mhz Pentium III
  •     128MB RAM
  •     Available PCI/PCI Express Slot

Contact us:

Mobile:  +971 54 4551689
All rights reserved for SENA Co.
scroll to top