OpenVox A810 Analog Card

OpenVox A810 is a new analog card. It can be used for connecting analog telephones and analog POTS lines through a PC.AE810 can takes full advantage of Octasic® Hardware Echo Cancellation Module to deliver the superior voice quality on both FXO and FXS interfaces in all 8 ports.

Adjustable Interrupt Routing Design
Interrupts Frequency Adjustment
Up to 8 Simultaneous PSTN Calls (Per PCI Slot)
Compatible with All Commercially Available Motherboards
Octasic® Hardware Echo Cancellation Module Available

Openvox A810 is an analog card with interchangeable quad-FXS and quad-FXO modules. It can eliminate the requirement for separate channel banks or access gateways.
The A810 contains 2 module banks. Each bank supports one analog interface. The module banks may be filled with up to 2 quad-FXO or quad-FXS modules enabling the creation of any combination of ports. Scaling of an analog card solution is accomplished by simply adding additional cards.
AE810 is a new generation analog card with Octasic® Hardware Echo Cancellation Module on board. With the interchangeable quad-FXS and quad-FXO modules.
Once the Octasic® DSP module EC2032 is added to the AE810P, please make sure you are ready to say goodbye to the poor voice quality and echo echo echo in your phone system. No one will even get a chance to hear that any more! The AE810 with Octasic DSP module will support Telco-grade hardware echo cancellation on all channels, up to the card’s maximum configuration in 8 ports with no additional CPU load.
A810 works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications.

OpenVox Elastix&trixbox certified

Target Applications

Channel Bank Replacement / Alternative
Small Office Home Office (SOHO) applications
Small and Medium Business (SMB) applications
Gateway Termination to analog telephones/lines

Specifications

Up to 8 ports through a combination of FXS400 and FXO400 modules
Half-length analog card
Up to 2 quad FXS or FXO modules
RJ11 connector
32-bit 33MHz PCI and fully PCI 2.3 compliant, compatible with all commercially available motherboards,
and proper sharing of PCI interrupts
32 bit bus master DMA data exchanges across PCI interface at 132 Mbytes/sec
Autosense compatibility with 5 V and 3.3 V PCI busses compatible
FPGA design, upgradeable firmware onsite
Power: 7.83W Minimum, 30.43W Maximum at 3.3 V or 5 V.
Operation temperature: 0°C to 50 °C
Storage temperature: -40°C to 125°C
Size: 13.6*11.2*1.8cm
Weight: 88g

Optional Octasic® DSP Echo Cancellation Module — EC2032

1024 taps/128 ms tail/channel (on all channel densities)
Octasic® music protection
Automatic level control (G.169)
Field upgradeable algorithm
V.25 / V.8 answer tone
DTMF as per Q.24
No CPU load as a result of echo cancellation.
Does not increase the physical size of the card, and no additional slot is required
EC2032 (SMEC V1.1) power: 3.83W
Operating Systems: Linux (all versions, releases and distributions from 1.0 up)

Minimum Hardware Requirement: