The security that comes with being able to control who comes into your building along with the ability to verbally and visually confirm their identity is immeasurable. Akuvox's Video Doorphone R20K enables you to easily monitor an entrance door or gate and gives you the peace of mind knowing that your facility is more secure.
|
Physical Features
Body material: Aluminum alloy
Camera: 3M pixels, with automatic lighting
RF card reader: 13.56MHz and 125kHz
PoE IEEE802.3af
12V DC connector (if not using PoE)
Light sensor: Support
Infrared sensor: Support
Installation: flush mounting or wall-mounting
Flush-mounted DIM: 226 x 108 x 52 mm
Wall-mounted DIM: 185 x 85 x 24 mm
Interface Features
1 x 10/100M Mbps Ethernet port
Output relay: 2 output relays for door opener
Relays controlled individually by DTMF tones
Wiegand port: Support
SIP Features
SIP v1 (RFC2543), SIP v2 (RFC3261)
Codec: G.711a, G.711μ, G.722 and G.729
Audio Features
Echo Cancellation
Voice Activation Detection
Comfort Noise Generator
Video Features
Resolution: up to 1280 x 720p
Maximum image transfer rate: 720p - 30fps
Camera permanently operational
Auto-night mode with LED illumination
Illumination: 0.1LUX min.
Auto white balance
Internal light sensor: image lighting during dark hours
Codec: H.264
Compliance with ONVIF
Deployment & Maintenance
Auto-provisioning
Web management portal
Web-based packet dump
Configuration backup / restore
Entry log export
Networking & Protocol
Protocols support: IPv4, HTTP, HTTPS, FTP, SNMP, DNS, NTP, RTSP, RTP, TCP, UDP, ICMP, DHCP, ARP
Application Scenarios
Office door phone with on-site or hosted IP-PBX
Remote site entry over Internet
Apartment/flat intercom with door access control